Powers as many as (2) 24VAC buzzers, or (6) 24VAC bells
Or up to 10 110VAC bells and buzzers
************ We build it to match the equipment you order.
Example: Electronic Punch or biometric clocks:
They can only accept up to .1amp, 30 volts. Our simple, hand-built device sends a whisper of a small current (12 to 18 volts, .05 amps) through the electronic circuit in the clock, isolating it from the 110VAC, 3 amp "blast" that would normally electrocute the sensitive timing circuitry inside.
Each assembly is unique - depending on high or low voltage requirements.
Low-voltage bells and horns:
Low voltage means no ISO 9000 conduit needed - if that is an issue.
2-pole ten-amp relay electrically isolates your expensive equipment from feedback.
In a metal box, nothing else needed other than wall mounting screws.
Saves you a trip to the hardware supplier, then the electronics store,
figuring it out and assembly time...Comes pre-wired...
Guaranteed for 2 years!
What's included* - we build this for you, we have the parts:
This can vary from system to system.
1 4“ metal box with extension* and cover plate. Sometimes it's plastic.
1 10 amp dual pole mechanical relay when needed.
1 110VAC power cable with plug
2 Metal box moly connectors
1 2 Amp 110 to 24VAC reduction coil when needed.
* This will power two 24VAC Edwards buzzers or 6 low voltage AC bells.
1 Additional electronic equipment - as needed*
Hours of work to source the parts, assemble and test this.
*Note: Parts may vary depending on the machine they are running.
We currently have eleven different configurations,
each one is unique to several clocks and timers.
This is a complete solution. You don't have to hunt-around, you don't have to invent it. We've done it for you. The wires are labled and ready connect, ready to run.